The development of electric furnace dust remover has been very stable in recent years, which is also due to the gradual reduction of the use of boilers and the increasing number of manufacturers using electric furnaces. The design of the installation system of electric furnace dust remover is very important. Only a device that is consumed according to a perfect and rigorous design can reach the ideal working state. Let's have a detailed understanding

The installation system of electric furnace dust remover is introducing new and high technology from time to time. Because the electric furnace factory will produce a lot of flue gas during processing, the flue gas is managed by the suction of the centrifugal main fan, and the flue gas is led out from the semi-closed electric furnace along the flue head_ Enter a secondary extinguishing chamber and pre-dust collector. The coarse particles and sparks are separated to fully extinguish the smoke and dust. The extinguished smoke enters a heat exchanger to reduce the flue gas temperature, and then is sent to the bag filter by a fan. The dust remains in the filter bag. The purified smoke is discharged into the atmosphere through the top of the dust collector, and the fine powder under the ash hopper is manually or mechanically put into the bag and output. In order to reduce the efficiency and short service life of the electric furnace dust remover used by some manufacturers, the major problem of many manufacturers is that the construction and setting parameters of the electric furnace dust remover are not corresponding, and the high output consumption under the condition of high voltage_ The load is wrongly used to generate serious stab fire, the proportion is not strict, and the smelting method is improper to form serious stab fire

Industrial silicon smelting is continuously stopped under the submerged arc state of electric furnace. During the operation, the arc closing operation shall be achieved, the furnace shall be charged and rammed in time, and the ratio of furnace charge resistance and current voltage shall be adjusted. The above is the installation system of the electric furnace dust remover introduced. Our factory has strict requirements for the consumption design of each kind of dust removal equipment. Our electric furnace dust remover has many advantages, for example, the system in the furnace is well set, and the furnace charge goes down according to the next order; The arc light is not exposed and the blast furnace temperature is maintained continuously; Electricity_ Balanced and stable consumption to prevent power failure_ break; The temperature of charge surface is low, which improves the application rate of electric furnace equipment; The amount of dust is less, which can provide a better environment for electric furnace operation